Hot Tub Electrical Requirements in Colorado: Circuit, Disconnect, Bonding and Permits
A hot tub under a Colorado sky is worth doing right. The delivery crew will not fill the tub until the electrical is in place, so here is exactly what the electrician installs and why.
The circuit
Most 240V spas need a dedicated 50 amp circuit; larger swim spas and tubs with big heaters need 60. It must be GFCI protected, either at the breaker or in the disconnect. Details are on our hot tub & spa electrical page.
The disconnect
A disconnect switch must be within sight of the tub, at least 5 feet away and readily accessible. It lets you or a technician kill power without going to the panel.
Bonding
Metal within 5 feet of the water, including the pad rebar, rails and the pump, is bonded together so there is no voltage difference a bather could touch. This is the step DIY installs miss most.
Panel capacity
Adding 50 amps to a full 100 amp panel is often the trigger for an electrical panel upgrade. We check load before you buy the tub.
Permits
Spa circuits require an electrical permit and inspection in nearly every Colorado jurisdiction. We pull it and meet the inspector.
Bottom line
We wire hot tubs, saunas and cold plunges statewide, including hot tub & spa electrical in Breckenridge, hot tub & spa electrical in Vail, hot tub & spa electrical in Evergreen, hot tub & spa electrical in Parker and hot tub & spa electrical in Fort Collins.