50 and 60 amp GFCI spa circuits, spa disconnects within sight of the tub and equipotential bonding of pads, decks and rails for homes and businesses in every Colorado city.
A hot tub on a snowy night is one of the best reasons to live in Colorado. Getting the electrical right is what keeps it safe. We install the GFCI-protected 50 or 60 amp circuit, the disconnect within sight of the tub, bonding for the pad and deck, and any lighting or outlets nearby, all to the standards your spa manufacturer and inspector require.
Under-cabinet lighting and new pendants over the island. The electrician coordinated with our cabinet guy so everything landed where it should.
Heather B.Outlets in the kitchen kept dying. Turned out to be a bad GFCI feeding the whole run. In and out in under an hour.
Rick D.Tesla Wall Connector installed in the garage, permitted and inspected, with load management so we did not need a new panel. Exactly what we hoped for.
Nadia L.It depends on the distance from the panel and whether trenching is needed. We quote flat after a short visit and include the disconnect and permit.
Yes. A dedicated GFCI-protected circuit, typically 50 amps, with a disconnect located at least five feet from the tub but within sight.
Some 110V plug-and-play tubs can, but they still need a GFCI-protected dedicated circuit. Most tubs require 240V hardwiring.
Moisture in the heater or a failing component is the usual cause. We test the circuit first, then advise if it is the spa itself.
Choose your city for local pricing, service details and nearby areas.
Flat pricing, real dispatchers, 24/7 across Colorado.